Ashley Sling,alloy chain slings
home About Ashley Sling alloy chain sling inspection Contact Site Map
ALLOY CHAIN SLINGS, WIRE ROPE SLINGS , RIGGING
HARDWARE, FALL PROTECTION, HOISTS and more . . .
arrow
 Alloy Chain Slings
arrow Grab IQ Alloy Chain Slings
arrow Wire Rope Slings
arrow Nylon Web Slings
arrow Polyester Round Slings
arrow High Performance Round Slings
arrow Wire Mesh Slings
arrow TUFF-ASH ® Sling Protection Products
arrow Linton Magnetic Sling Protectors
arrow Crosby Rigging Hardware
arrow Wire Rope
arrow Samson Synthetic Rope
arrow Hoists
arrow Fall Protection
arrow Fall Protection for Tools
arrow Netting Systems
arrow Tie Down Equipment
arrow Plate Clamps
arrow Lifting Beams
arrow Load Testing Equipment
arrow Lifting Magnets
arrow Training Seminars
arrow OSHA Regulations & Guidelines
arrow Klein Iron Workers Tools
arrow Safety Products

END CAP SPREADER BEAM (Model BEF)
<Back Next>
 
adjustable spreader beam
 
PRODUCT FEATURES:
• Build your own spreader beam.
• Designed to work with a range of shackle sizes, both top and bottom.
• Complies with ASME standards when assembled to specifications using A53 Grade B, schedule 40 pipe.

  end cap
 
ASSEMBLY INFORMATION

 
The Model BEF is designed to use A53 Grade B, schedule 40 pipe as the central structural element between the end fittings. This structural material is readily available at most steel service centers. The Model BEF-2 1/2 requires a 2-1/2" nominal size, the Model BEF-5 requires a 5" nominal size, and the BEF-8 requires an 8" nominal size A53 Grade B, schedule 40 pipe.

Other requirements are:

•The length of pipe used for this central element must be straight within 1/4" end to end.
• The pipe should have the ends cleanly cut square with its centerline.
• The A53 Grade B, schedule 40 pipe should not have any weld joint irregularities.
• Each end of the A53 Grade B, schedule 40 pipe must have the correct diameter holes drilled through both walls and both
  ends must be in line.
• The A53 Grade B, schedule 40 pipe used in this application does not need to pass any pres-sure testing.

The retaining bolts used to secure the Model BEF 2-1/2 and 5 to the A53 Grade B, schedule 40 pipe must be a Grade 5 Hex Head Cap Screw 5/8-11 with minimum length of 4-1/2" and 8" respectively. The bolt for the BEF-8 is a Grade 5 Hex Head Cap Screw 1-8 with a minimum length of 11-1/2".

NOTE: Complete assembly instructions are provided with each set of end fittings.


 

  spacer
Atlanta, GA
404-691-2604
Slings Atlanta, GA
Charlotte, NC
704-347-0071
Slings Charlotte NC
Chattanooga, TN
423-867-9380
Slings Chattanooga
Columbus, MS
662-328-4040
Slings, Columbus
Knoxville, TN
865-675-1225
Slings Knoxville, TN
Nashville, TN
615-259-5121
Sling Nashville, TN